Nvidia MSTFLINT Manual page 120

mstdump Added support for the mstdump utility (at beta level)
mstmcg Renamed mcg to mstmcg
spark spark was removed from mstflint version 3.0.0
Supported The following adapter cards and switch systems are no longer
Devices supported in mstflint version 3.0.0:
• InfiniHost 4X
• InfiniHost III Ex
• InfiniHost III Lx 4X
• InfiniScale
• InfiniScale III
Rev. 2.7.2b
All Added support for WinPE 4.0 OS
Rev. 2.7.2
General It is no longer required to run mst start/stop when using
Winmstflint tools. The service is automatically loaded/unloaded
when an mstflint tool is running. The mst service installation was
removed from the setup
Added support for SwitchX® silicon devices
mstflint Added support for Atmel AT25DFxx flash family
Added support for burning firmware via Command Line Interface
(CLI) on SwitchX® devices
mget_temp mget_temp displays a more accurate temperature reading for
ConnectX®-2 and ConnectX®-3 devices by using the adapter's
specific thermal calibration data
Rev. 2.7.1a
Added the mcg The mcg tool displays the current multicast groups and flow
tool (Beta level) steering rules configured in the device.
Target users: Developers of Flow Steering aware applications. This
tool dumps the internal steering table which is used by the device to
steer Ethernet packets and Multicast IB packets to the correct
destination QPs.
Each line in the table shows a single filter and a list of destination
QPs. Packets that match the filter are steered to the list of
destination QPs
Linux/
Windows
Linux/
Windows
Linux/
Windows
Linux/
Windows
Windows
Windows
Windows
Windows
Windows
Windows
Linux
120