1-18
Dell PowerVault Storage Systems — Rack Installation Guide
Installing Two 800-W SPS Units in the 800-W SPS Tray
1.
Insert the two 800-W SPS units in the 800-W SPS tray.
2.
Fasten the three mounting brackets to the SPS units and to the tray as shown in
Figure 1-15. Tighten all screws securely.
SPS unit (2)
mounting brackets (3)
with captive Phillips-
head screws
Figure 1-15. Installing Two 800-W SPS Units in the Tray
3.
Attach a mounting bracket to the left corner of the left-hand SPS unit using two
captive Phillips-head screws on the right side of the mounting bracket.
4.
Secure the two remaining Phillips-head screws on this mounting bracket to the
left side tray mounting flange (as viewed from the back).
5.
Attach a mounting bracket to the right corner of the right-hand SPS unit using two
captive Phillips-head screws on the left side of the mounting bracket.
6.
Secure the two remaining screws on this mounting bracket to the right-hand side
tray mounting flange.
7 .
Connect the two SPS units in the center using a mounting bracket and four cap-
tive Phillips-head screws.
8.
Fasten the SPS units to the front of the 800-W tray by inserting a Phillips screw-
driver through the holes in the front of the tray and securing the captive screws
into each SPS unit.
captive screws (4)