Figure 1-14. Fastening A Single 800-W Sps Unit In The Tray - Dell PowerVault 630F Installation Manual

support.dell.com
During a later installation procedure, you will be connecting (from the back) the SPS
on the left to power supply A (PS A), and connecting its interface cable to storage pro-
cessor A (SP A). Consider the SPS on the left as Unit SPS A. The second SPS (if any)
will be connected to PS B, and its interface cable connected to SP B. Consider the
SPS on the right as Unit SPS B.
CAUTION: The SPS weighs 9.1 kg (20 pounds). Remove with care.
1. Carefully insert the SPS into the 800-W SPS tray (see Figure 1-14).
SPS unit
mounting bracket
with captive Phillips-
head screws
filler panel

Figure 1-14. Fastening a Single 800-W SPS Unit in the Tray

2. Secure the left side of the SPS to the left mounting flange with a mounting
bracket with captive Phillips-head screws.
3. Install a filler panel over the vacant slot on the right-hand side of the tray, using
the four captive Phillips-head screws on the filler panel.
4. Fasten the SPS unit to the front of the 800-W tray by inserting a Phillips screw-
driver through the holes in the front of the tray and securing the captive screws
into the SPS unit.
Dell PowerVault Storage Systems — Rack Installation Guide 1-17
captive screws
(2 per SPS)