Installing The 800-W Sps Tray Hardware; Figure 1-12. Back Cage-Nut Location For An 800-W Sps Tray - Dell PowerVault 630F Installation Manual
Rack installation guide
Hide thumbs
Also See for PowerVault 630F:
- Documentation update (14 pages) ,
- Information update (13 pages)
Table of Contents
Advertisement
support.dell.com
1/2-U increment
in vertical rail
1-U increment
in vertical rail
location of lower
edge of SPS tray
Figure 1-12. Back Cage-Nut Location for an 800-W SPS Tray
Installing the 800-W SPS Tray Hardware
1.
Install the two cage-nuts used to secure the back of the tray to the rack's back
vertical rails at the back of the rack cabinet.
2.
Install the 10-32 cage-nuts at the two locations you marked on the back vertical
rails:
a.
Position the cage-nut and cage-nut tool as shown in Figure 1-7 .
b.
Push in on the cage-nut while rotating the cage-nut tool up and pulling the
tool back toward you until the top lip of the cage-nut snaps into position (see
Figure 1-7).
c.
Repeat steps a and b to install the remaining cage-nut on the other back ver-
tical rail.
3.
Install the 800-W SPS tray in the rack (see Figure 1-13):
a.
Insert the tray into the back of the rack cabinet.
b.
Slide the tray into the rack so that the tabs on the lower back of the tray
flange mount in the back vertical rails when the holes in the back tray mount-
ing flange align with the cage-nuts.
Dell PowerVault Storage Systems — Rack Installation Guide 1-15
1 U
1.5"
back vertical rail
location of cage-nut
for SPS tray
larger gap between
holes in vertical rail
smaller gap between
holes in vertical rail
Advertisement
Table of Contents
