Rack Kit Components - Dell PowerVault 630F Installation Manual

support.dell.com
Dell PowerVault
™
Storage Systems and Standby
Power Supply Rack Installation
Guide
This guide provides instructions for installing one or more Dell PowerVault 630F Disk
Array Enclosure (DAE) or PowerVault 650F Disk Array Processor Enclosure (DPE) stor-
age systems, and an 800-watt (W) or 900-W Standby Power Supply (SPS) in a Dell
rack.

Rack Kit Components

The rack kit includes some of the following items (see Figure 1-1)
•
One pair of support rails (DPE and DAE only)
•
One or two SPS units (800-W or 900-W)
•
One tray assembly (800-W SPS tray or 900-W SPS tray)
•
Two retention brackets (DAE or DPE)
•
One cage-nut installation tool (DPE and SPS tray)
•
Six 10-32 (or M5) pan-head Phillips-head screws (800-W SPS tray)
•
Ten or 16 M4 x 10-millimeter (mm) pan-head Phillips-head screws with attached
washers (900-W SPS tray)
•
Six M5 x 16-mm pan-head Phillips-head screws with and without attached wash-
ers (800-W SPS tray)
•
Four #10 (or M5) flat metal washers
•
Four 10-32 (or M5) cage-nuts
•
Three mounting brackets and filler plate (900-W SPS only)
•
Two front mounting brackets and bezel (800-W SPS tray only)
NOTES: The number of parts may vary, depending on the equipment you ordered.
If you have purchased a Dell rack along with your PowerVault storage system, the support
rails and tray are preinstalled in the rack.
630F and 650F
™
Dell PowerVault Storage Systems — Rack Installation Guide 1-1