support.dell.com
2.
Attach a mounting bracket to the left corner of the SPS unit using two
M4 x 10-mm Phillips-head screws with attached washers.
3.
Attach a filler plate to the right corner of the SPS unit using two M4 x 10-mm
screws with attached washers.
4.
Using four M4 x 10-mm Phillips-head screws with attached washers, secure the
outer ends of the SPS unit and filler panel to the mounting holes in the tray
flange.
5.
At the front of the rack cabinet, use two M4 x 10-mm Phillips-head screws with
attached washers to secure the front end of the SPS unit to the tray (as viewed
from the front of the rack cabinet).
Installing Two 900-W SPS Units in the Tray
1.
Insert the two 900-W SPS units into the tray (see Figure 1-11).
SPS units (2)
M4 x 10-mm Phillips-
head screws with
attached washers
(16)
mounting bracket (3)
Figure 1-11. Installing Two 900-W SPS Units in the Tray
2.
Attach a mounting bracket to the left corner of the left-hand SPS unit using two
M4 x 10-mm Phillips-head screws with attached washers.
Dell PowerVault Storage Systems — Rack Installation Guide 1-13
mounting bracket nuts (4)
M4 x 10-mm Phillips-
head screws with
attached washers