Installing The 900-W Sps Tray Hardware; Figure 1-6. Front Cage-Nut Location For A 900-W Sps Tray - Dell PowerVault 630F Installation Manual

support.dell.com
1/2-U increment
in vertical rail
1-U increment
in vertical rail
location of lower
edge of SPS tray

Figure 1-6. Front Cage-Nut Location for a 900-W SPS Tray

Installing the 900-W SPS Tray Hardware

1. Install the two cage-nuts used to secure the front of the tray to the rack's front
vertical rails at the front of the rack cabinet.
2. Install the M5 cage-nuts at the two locations you marked on the front vertical
rails:
a. Position the cage-nut and cage-nut tool as shown in Figure 1-7 .
b. Push in on the cage-nut while rotating the cage-nut tool up and pulling the
tool back toward you until the top lip of the cage-nut snaps into position (see
Figure 1-7).
c. Repeat steps a and b to install the remaining cage-nut on the other front ver-
tical rail.
Dell PowerVault Storage Systems — Rack Installation Guide 1-9
IU
7/8"
front vertical rail
location of cage-nut
for SPS tray
larger gap between
holes in vertical rail
smaller gap between
holes in vertical rail