Sending A Fax After Calling (Manual Transmission) - Konica Minolta bizhub 306 User Manual

3
3.7

Sending a fax after calling (Manual transmission)

If this machine is connected to an external phone while a single line is shared between the phone and fax
modes, you can send the original after talking on the phone with a recipient.
This function is available when notifying a recipient that an original has been sent.
Tips
- Memory TX is not available when using the manual transmission.
- If a recipient is ready to automatically receive data (in the auto answer state), you will hear a "long beep"
instead of a recipient's answer. In this case, you cannot speak to a recipient.
- When sending a fax after calling, use the ADF.
- The manual transmission is available when an external phone is connected to the TEL port of this ma-
chine.
1
Load the original onto the ADF.
% For details on how to load the original, refer to page 3-5.
2
When necessary, specify a image quality.
% For details on Quality, refer to page 3-7.
3
Pick up the phone receiver.
% Check that you hear a dial tone "long beep" through the receiver.
% When using a dialing telephone line, you can type in
4
Specify a destination.
% Use the dial buttons of the phone to dial a fax number.
% You can also specify a destination using the Control Panel of this machine (p. 3-8).
5
After speaking, ask a recipient to press the Start key.
When the machine is ready, a "long beep" sounds.
6
Press the Start key.
This starts scanning and sending.
7
Put down the receiver.
% To stop sending, press the Clear/Stop key, then select [YES] in the displayed screen.
Tips
Press the On Hook key instead of picking up the receiver; the speaker becomes active, and you can perform
the manual transmission in the same way as for the above.
3-19
Sending a fax after calling (Manual transmission)
MEMORY
QUALITY:STD/TEXT
*OFF HOOK*
to output a signal for a push telephone line.
3.7
bizhub 306/266