Network Interface; Sts-1 Configuration; Line Length; Timing - ADTRAN 1200287L1 User Manual

NETWORK INTERFACE

Select
parameters (see Figure 3-3). Configure the MX2800 STS-1
network settings to match the STS-1 signal received from the
service provider.

STS-1 Configuration

Use the
configure the STS-1 network settings to match your application.

Line Length

Set the line length to reflect the physical length of the STS-1
network line. Set to
225-450 feet; set to

Timing

Selects the source of timing used to derive the transmit signal. The
MX2800 STS-1 has three modes of timing operation:
R
clocking from the STS-1 receive signal. Loss of the STS-1 receive
61200659L1-1
N I
ETWORK NTERFACE
STS-1 C
ONFIGURATION
L
S
HORT
, and .
E L
UN XTERNAL
MX2800 STS-1 User Manual
to access the network configuration

Figure 3-3. Network Configuration Menu

selections described below to
if the cabling distance is between
ONG
if the distance is less than 225 feet.
timing configures the unit to recover
OOP
Chapter 3. Configuration
,
L F -
OOP REE
3-3