Table of Contents
Advertisement
Chapter 3. Configuration
Idle Timeout
After establishing a call and sending trap messages, the MX2800
STS-1 remains online for the amount of seconds entered in this
field. If the field is set to 0, the unit hangs up as soon as the trap is
sent.
Connection Timeout
The MX2800 STS-1 waits for a connection the amount of seconds
entered in this field. Timing begins as soon as the dial command is
issued. This field must be set for greater than 20 seconds.
Pause Between Calls
The MX2800 STS-1 waits between redial attempts the number of
seconds entered in this field.
Dialout On Trap
Enable or disable the MX2800 STS-1's ability to dial out to report
traps.
in plain ASCII with the following information:
•
•
•
•
When
STS-1 logs into the PPP/SLIP host and reports the error conditions
to the hosts designated under
Addresses on page 3-25).
Answer on Ring
Enable or disable the MX2800 STS-1's ability to accept incoming
calls. If enabled, incoming calls are automatically answered by the
MX2800 STS-1, allowing you to remotely perform management
functions.
3-16
M
M
configured for
ODEM
ODE
The Unit ID value programmed in the E
portion of the S
YSTEM
Management on page 3-13)
A trap code indicating the error condition
A text description of the fault
The date and time when the error was logged
is configured for
M
M
ODEM
ODE
MX2800 STS-1 User Manual
VT-100
reports error conditions
QUIPMENT
M
screen (see System
ANAGEMENT
or
PPP
T
IP A
RAP
DDRESSES
I
DENTIFICATION
, the MX2800
SLIP
(see Trap IP
61200659L1-1
Advertisement
Table of Contents
