Transmitting Measured Values; Information List - Siemens SIPROTEC 6MU805 User Manual

Functions
2.3 Additional Functions
same applies to the power factor cos. It is occasionally desired to define the power drawn from the line (e.g.
as seen from the consumer) positively. Using parameter 1108 P,Q sign the signs for these components can be
inverted.
The calculation of the operational measured values also takes place while a fault is running. The values are
updated at intervals of > 0.3 s and < 1 s.

2.3.3.2 Transmitting Measured Values

The main propose of the measured values in the MU is to support the commissioning. Measured values can
also be transmitted to a central control and storage device via port F.
The measuring range in which these values are transmitted depends on the protocol and additional settings, if
applicable.
Protocol
IEC 61850

2.3.3.3 Information List

No.
601 IL1 =
602 IL2 =
603 IL3 =
604 IN =
605 I1 =
606 I2 =
621 UL1E =
622 UL2E =
623 UL3E =
624 UL12=
625 UL23=
626 UL31=
627 Uen =
629 U1 =
630 U2 =
641 P =
642 Q =
644 Freq=
645 S =
680 Phi L1 =
681 Phi L2=
682 Phi L3 =
831 3I0 =
832 U0 =
901 PF =
44
Transmittable measuring range, format
The primary operational measured values are transmitted.
The measured values as well as their unit format are set out in detail in the PIXIT docu-
ment of the 6MU805 device.
The measured values are transmitted in "Float" format. The transmittable measuring
range is not limited and corresponds to that of the operational measurement.
Information Type of Information
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
MV
Comments
IL1 =
IL2 =
IL3 =
IL4 =
I1 (positive sequence)
I2 (negative sequence)
UL1E =
UL2E =
UL3E =
UL12=
UL23=
UL31=
Uen =
U1 (positive sequence)
U2 (negative sequence)
P (active power)
Q (reactive power)
Frequency
S (apparent power)
Angle Va-Ia
Angle Vb-Ib
Angle Vc-Ic
3I0 (zero sequence)
V0 (zero sequence)
Power Factor
SIPROTEC, 6MU805, Manual
C53000-G1140-C380-5, Release date 06.2018