Crestron UPX-2 Reference Manual page 20

Universal Presentation Processor
Source Assignment
Procedure
16 ¥ UPX-2: Universal Presentation Processor
There are two ways to assign a source for video windows and display output B.
Defaults
Defaults allow the user to assign the video source to be used when the video
object is displayed. The selection can be overwritten with an analog join.
Joins
Joins allow the user to select the source of a video window via analog joins.
1. Draw a video or an RGB window.
2. Double-click the window to view the window's properties.
3. In the lower left hand corner of the window use the pull-down menu
under Select Property to Modify and assign an analog value for height,
left, top and width. Refer to "Changing Size and Position with Analog
Joins" on page 14.
4. Select the source for the audience (Output B) by selecting the Display
Output tab of the "Project Properties" window in VT Pro-e and choose
an analog join number.
"Project Properties" Display Output Tab
In this example, analog join 25 is assigned in the "Project Properties"
window. The analog value assigned to this join will determine the
output to the audience display on output B.
5. In SIMPL Windows, select the appropriate analog value to select the
input source.
NOTE: When used with video windows, invalid values (out of 0-13d
range) are not treated as 0d but instead black-out the display. The
behavior is the same as if a valid source value was sent and there was
no source connected to that input.
NOTE: Graphics = Same as output A
None = Black. Values out of 0-13d range black-out the
display.
Crestron UPX-2
Reference Guide – DOC. 6286A