Universal Presentation Processor Crestron Upx - Crestron UPX-2 Reference Manual

Universal Presentation Processor
Symbol Programming
10 ¥ UPX-2: Universal Presentation Processor
RGB Video Properties for Touch-the-PC
6. In SIMPL Windows, right-click on slot 1 of the UPX-2 in Program View
and select Insert Device Extender, then select UPX-2/UPX-2-MSO/UPX-
2_1GB Touch Out to begin programming.
The following is a "touch out" programming example for RGB-1. A description for
each signal in the symbol is described in the SIMPL Windows help file (F1).
NOTE: The current UPX-2 firmware release only supports UPDD formats.
1. Add an analog initialize 0d to the Touchout Format RGB-1 signal.
2. Add an analog value to Touchout Destination RGB-1 to specify the
"touch out" destination.
0X02 – via Cresnet
0X03 through 0XFE – via Ethernet where 03 to FE are Device ID
numbers.
Assigning Device ID numbers allows multiple touchpanels to be attached to
a control system using the same Device ID for Touch-the-PC. Therefore, a
TPS touchpanel that has an IP ID of 04 and a UPX-2 with an IP ID of 03
can both have the same Device ID of 04. The IP Tables in the control
system and the UPX-2 must be modified to have the Device ID. For
example, an IP table entry with IP ID 03 and IP address 188.148.124.5, will
need the Device ID number 04. After the Device ID has been added to the
entry, the device will be listed as 03 188.148.124.5 04 where 03 is the IP
ID, 188.148.124.5 is the IP address, and 04 is the Device ID.
3. Take serial string Touchout String RGB-1 to the COM port of the 2-Series
control system TX$.
Crestron UPX-2
Reference Guide – DOC. 6286A