Table of Contents
Advertisement
7-26
Starting and operating/Continuously variable transmission
"
" appears, downshifting is possible.
When both indicators appear, upshifting
and downshifting are both possible. When
the vehicle stops (for example, at traffic
signals), the downshift indicator turns off.
Gearshifts can be performed using the
shift paddle behind the steering wheel.
To upshift to the next higher gear position,
pull the shift paddle that has "+" indicated
on it. To downshift to the next lower gear
position, pull the shift paddle that has "–"
indicated on it.
To deselect the manual mode, return the
select lever to the "D" position from the "M"
position.
While driving with the select lever in the "D"
position, if you change gears by operating
the shift paddle, the gear position indicator
light illuminates and shows the current
gear condition.
CAUTION
Do not place or hang anything on the
shift paddles. Doing so may result in
accidental gear shifting.
NOTE
Please read the following points care-
fully and bear them in mind when using
the manual mode.
. If you attempt to shift down when the
engine speed is too high, i.e., when a
downshift would push the tachometer
needle beyond the red zone, beeps will
be emitted to warn you that the down-
shift is not possible.
. If you attempt to shift up when the
vehicle speed is too low, the transmis-
sion will not respond.
. You can perform a skip-shift (for
example, from 4th to 2nd) by operating
the shift paddle twice in rapid succes-
sion.
. The transmission automatically se-
lects 1st gear when the vehicle stops
moving.
. If the temperature of the transmis-
sion fluid becomes too high, the "AT
OIL TEMP" warning light on the combi-
nation meter will illuminate. Immedi-
ately stop the vehicle in a safe location
and let the engine idle until the warning
light turns off.
. By selecting the Sport Sharp (S#)
mode, upshifting will not occur auto-
matically. According to the road condi-
tions, shift change manually so that the
tachometer needle does not enter the
red zone. Also, if the engine revolutions
reach the specified number, the fuel
supply will be cut. In this case, perform
shift up operation.
! To deselect the manual mode
To deselect the manual mode, return the
select lever to the "D" position from the "M"
position.
& Shift lock function
The shift lock function helps prevent the
improper operation of the select lever.
. You cannot move the select lever with
the ignition switch in the "ON" position and
the brake pedal depressed.
. You cannot move the select lever from
the "P" position to any other position
unless the brake pedal is depressed.
Depress the brake pedal first, and then
operate the select lever.
. Only the "P" position allows you to turn
the ignition switch from the "ACC" position
Advertisement
Chapters
Table of Contents
