Shift Lock Function - Subaru Outback 2011 Owner's Manual

7-22
Starting and operating
of an accident is consequently in-
creased.
! D (Drive)
This position is for normal driving. The
transmission automatically shifts into a
suitable gear according to the vehicle
speed and the acceleration you require.
When more acceleration is required in this
position, depress the accelerator pedal
fully to the floor and hold that position. The
transmission will automatically downshift.
When you release the pedal, the transmis-
sion will return to the original gear posi-
tion.
To use the manual mode, move the lever
from this position into the manual gate.
NOTE
For models with SI-DRIVE:
When depressing the brake pedal with
the select lever in the "D" position after
the vehicle has completely stopped,
the transmission automatically shifts to
neutral. Before driving again, the trans-
mission will engage again approxi-
mately 1 second after the brake pedal
is released.
! While climbing a grade
When driving up a hill, undesired upshift is
prevented from taking place when the
accelerator is released. This minimizes
the chance of subsequent downshifting to
a lower gear when accelerating again.
This prevents repeated upshifting and
downshifting resulting in a smoother op-
eration of the vehicle.
NOTE
The transmission may downshift, de-
pending on the way the accelerator
pedal is depressed to accelerate the
vehicle again.
! While going down a hill (AT models)
When you are descending a hill or any
other slope while braking with the "S"
mode or "S#" mode selected, the trans-
mission may downshift to 4th or 3rd gear
depending on how hard you depress the
brake pedal, causing engine braking to
work. Reacceleration for a short time will
cause the transmission to upshift normally.
& Shift lock function
The shift lock function helps prevent the
improper operation of the select lever.
. The select lever cannot be operated
unless the ignition switch is turned to the
"ON" position and the brake pedal is
depressed.
. The select lever cannot be moved from
the "P" position to any other position
before the brake pedal is depressed.
Depress the brake pedal first, and then
operate the select lever.
. Only the "P" position allows you to turn
the key from the "Acc" position to the
"LOCK"/"OFF" position and remove the
key from the ignition key cylinder.
. If the ignition switch is turned to the
"LOCK"/"OFF" position while the select
lever is in the "N" position, the select lever
may not be moved to the "P" position after
a period of time. Therefore, move the
select lever to the "P" position with the
brake pedal depressed soon after the
ignition switch is turned to the "LOCK"/
"OFF" position.
! Shift lock release
If the select lever cannot be operated, turn
the ignition switch back to the "ON"
position then move the select lever to the
"P" position with the select lever button
pressed and brake pedal depressed.
If the select lever does not move after
performing the above procedure, perform
the following steps.