Table of Contents
Advertisement
NOTE
. If the access key fob is not detected
within the operating range, you cannot
operate the push-button ignition switch
or start the engine.
. Even when the access key fob is
outside the vehicle, if it is placed too
close to the glass, it may be possible to
switch the power or to start the engine.
. Do not leave the access key fob in
the following places. It may become
impossible to operate the push-button
ignition switch or start the engine.
– On the instrument panel
– On the floor
– Inside the glove box
– Inside the door trim pocket
– On the rear seat
– On the rear shelf
– Inside the trunk
. If the battery of the access key fob is
discharged, perform the procedure de-
scribed in "Access key fob – if access
key fob does not operate properly" F9-
18 to operate the push-button ignition
switch or start the engine. In such a
case, replace the battery immediately.
Refer to "Replacing battery of access
key fob" F11-52.
! Switching power status
Power
Indicator color
status
Power is turned
OFF
OFF
off.
You can use the
audio and ac-
ACC
Orange
cessory power
outlet.
Orange (while
the engine is
You can use all
stopped)
ON
electrical sys-
tems.
OFF (during en-
gine operation)
The power will be switched every time you
press the push-button ignition switch.
1. Carry the access key fob, and sit in the
driver's seat.
2. Shift the shift lever in neutral (MT
models) or the select lever in the "P"
position (CVT models).
3. Press the push-button ignition switch
without depressing the clutch pedal (MT
models) or the brake pedal (CVT models).
The power will be switched in the se-
quence of "OFF", "ACC", "ON" and "OFF".
When the engine is stopped and the push-
button ignition switch is in "ACC" or "ON",
the operation indicator on the push-button
ignition switch illuminates in orange.
Instruments and controls/Ignition switch
. To avoid a malfunction, observe
Operation
the following precautions.
– Do not spill drinks or other
liquids on the push-button
ignition switch.
– Do not touch the push-button
ignition switch with a hand
that is soiled with oil or other
contaminants.
. If the push-button ignition switch
does not operate smoothly, stop
the operation. Contact a SUBARU
dealer immediately.
. If the push-button ignition switch
does not illuminate even when
the instrument panel illumination
is on, have the vehicle inspected
at a SUBARU dealer.
. If the vehicle was exposed to
sunlight for a long time, the sur-
face of the push-button ignition
switch may get hot. Be careful
not to burn yourself.
3-7
CAUTION
– CONTINUED –
Advertisement
Chapters
Table of Contents
