Power Saving Function - Subaru WRX 2021 Owner's Manual

5. After a buzzer (ding) sounds once,
press the trunk opener button eight times.
6. Perform steps 1 to 5 again within
approximately 30 seconds after the buzzer
starts sounding intermittently.
7. All doors will be unlocked and locked.
Then the PIN code will be registered.
NOTE
. If you make an error during the
registration procedure, open the dri-
ver's door and then close it. Then, start
over from the procedure described in
"Preparation".
. To protect your vehicle from theft,
you cannot register "00000", "11111" to
"99999" or "12345" as a PIN code.
. Do not register your vehicle license
plate number or simple numbers such
as "11122" or "12121" as a PIN code.
Doing so will increase the risk of
vehicle theft.
. When you try to register "22222", the
registered PIN code will be deleted. You
cannot unlock the doors by PIN Code
Access until a new code is registered.
. After registering a new PIN code,
make sure that you can unlock the
doors using the PIN code.
. When you delete the PIN code while
the keyless access function is dis-
abled, the keyless access function will
Keys and doors/Keyless access with push-button start system
be enabled.
. Reregister the PIN code in the fol-
lowing case.
– When you forget the PIN code.
– When you want to change the PIN
code.
! Unlocking
Perform steps 1 to 5 described in "Regis-
tration".
NOTE
. You cannot unlock by PIN Code
Access in the following cases.
– The access key fob is within the
operating ranges.
– The ignition switch is in the
"ACC" or "ON" position.
. If you make an operation error dur-
ing the unlocking procedure, start over
with the unlocking procedure after
waiting for 5 seconds or longer.
. To protect your vehicle from theft, a
buzzer will sound if incorrect PIN codes
are entered five times continuously. If
this occurs, you cannot unlock the
doors by PIN Code Access for 5
minutes.
& Power saving function
The keyless access function will be dis-
abled in the following cases to protect the
battery of the access key fob and the
vehicle battery.
Case 1: When the keyless access function
and the remote keyless entry system have
not been used for 2 weeks or longer while
all doors are locked.
Case 2: When the access key fob has
been left in the operating range for 10
minutes or longer while all doors are
locked.
! Recovery from power saving mode
When one of the following is operated, the
keyless access function will be recovered.
Case 1:
. Unlock the doors by operating any
procedure other than gripping the front
passenger's door handle.
. Lock or unlock the doors.
. Open a door and then close it.
Case 2:
. Unlock the doors by gripping the door
handle.
. Lock the doors by touching the door
lock sensor.
– CONTINUED –
2-13