Display Message Registration Events - Nortel Meridian 1 Manual

Display message registration events

Follow these steps to have meter changes displayed.
1 To assign a terminal for meter display:
SEt OPtion POrt portID MEter DIsplay (ON) <CR>
2 The system DISPLAY option must be turned on to have any meter
changes displayed. To turn on the system meter display:
SEt OPtion DIsplay MEter (ON) <CR>
To turn it off again, just replace ON with OFf.
3 The meter for an individual DN must have its own display turned on as
well if you wish to display changes to it. This gives you the choice of
turning all meter displays on, or only those you require. To turn the
display of a particular meter or groups of meters on or off, refer to "Turn
meters on and off" on page 80.
A typical display message would look like this.
ROOM METER 1235 DISP 40 TO DISP 42 AT 16:00
The value of the meter for DN 1235 was changed from 40 to 42 at 4:00 pm.
Using the Background Terminal
Background Terminal Facility
Page 31 of 120
Description