Operating Parameters - Nortel Meridian 1 Manual
Background terminal facility
Hide thumbs
Also See for Meridian 1:
- Manual (1121 pages) ,
- Planning and installation manual (612 pages) ,
- Planning, installation and operating instructions (556 pages)
Table of Contents
Advertisement
Page 78 of 120
Message Registration
Operating parameters
553-2311-316
Standard 10.00
You can use X substitution (see "Define options for the Set command" on
page 17).
You may not be able to SEt all DNs at once if the ALl option is not on (see
"Define options for the Set command" on page 17).
You may not be able to SEt a group of consecutive DNs if the RAnge option
is not on (see "Define options for the Set command" on page 17).
All meters specified in the command are printed out, even if they were
already set at zero.
When erasing the meters for a group of DNs, the second DN entered must be
a higher number than the first.
The response shown in the examples appears only if the COnfirm option is on
(see "Define options for the Set command" on page 17).
VAlue 0 can be used instead of ZEro if you wish.
June 1999
Advertisement
Table of Contents
