Changing, Removing And Printing An Silc Or Uilc - Nortel Meridian 1 Administration And Maintenance

Changing, removing and printing an SILC or UILC

Changing an SILC or UILC
You can change a card type and the MISP card slot number with which the
SILC or UILC is associated. Before changing the SILC or UILC, you must
disable the card by executing the DISC c command in Diagnostic Program
LD 32. If you do not wish to change a parameter, press the Enter key and the
next prompt will appear.
LD 27 — Changing an SILC or UILC
Prompt Response
REQ CHG
TYPE CARD
TN 1-20
MISP 1-9
CTYP SILC,UILC
Removing an SILC or UILC
You can remove an SILC or UILC by specifying its card location. Before you
can remove the SILC or UILC, you must first remove all configured DSLs
from the card by using the Removing a DSL procedure. When you remove the
last DSL, you automatically delete the card.
When you remove (OUT) the card, you also delete its database information
from the data block. Print Program LD 20 can be used to list the cards that are
configured.
Chapter 8 — Service changes and maintenance
Comment
Change an SILC or UILC line card
SILC or UILC line card
Card slot location
The values for this prompt are1-20
Remove any DSLs that are configured for this line card
before changing the line card.
MISP card slot number
ISDN BRI applications on the MISP must be disabled
when changing the MISP card number.
The SILC or UILC must be disabled before changing
the MISP card slot number.
Card type
Option 11C ISDN BRI Administration and Maintenance
Page 331 of 492