Installing Silcs And Uilcs - Nortel Meridian 1 Administration And Maintenance

Chapter 5 — ISDN BRI line and packet data implementation

Installing SILCs and UILCs

The following procedure describes how to install SILCs and UILCs into the
Option 11 cabinets. Refer to the Card slot allocation plan for the card slot
assignments.
1 Remove the cover from the assigned cabinet.
The static discharge bracelet located inside the cabinet must be worn
before handling circuit cards. Failure to wear the bracelet can result in
damage to the circuit cards.
2 Remove the SILC or UILC from its shipping package and hold it by
its card locking devices.
3 Configure the line powering options for the SILC using the jumper
plugs. Each port is equipped with its own set of option jumper plugs
to allow individual configurations for each DSL.
The SILC has three line powering options. These options are configured
using the jumpers located near the backplane connector as shown in
Figure 27.
CAUTION
Option 11C ISDN BRI Administration and Maintenance
Page 199 of 492