Nortel Meridian 1 Administration And Maintenance page 344

Page 330 of 492
Prompt
CH
LD 27 — Removing a MISP
Prompt
REQ
TYPE
LOOP
LD 27 — Printing a MISP
Prompt
REQ
TYPE
LOOP
553-3011-311 Standard 7.0
Chapter 8 — Service changes and maintenance
Response Comment
1-23 PRI 1.5 Mb (1-23) or PRI 2 Mb (1-30) channel number
1-30 This channel carries B
To change this parameter, first disable the MISP.
This prompt appears only if you selected DCH or BDCH
for the PH prompt.
Removing an MISP
You can remove an MISP by specifying its card slot number. Before you can
remove the MISP, you must remove all DSLs connected to SILCs and/or
UILCs that are associated with the MISP.
Response Comment
OUT Remove an ISDN BRI component
MISP MISP
1-9 Card slot number
The MISP must be disabled before removing it.
All SILC and/or UILC DSLs associated with the MISP
must be removed before removing the MISP. Refer to
Removing an SILC or UILC in this chapter.
Printing an MISP
You can print the configuration information for an MISP by specifying its
card slot number.
Response Comment
PRT Prints an ISDN BRI component
MISP MISP
1-9 Card slot number
<cr> If you do not know the MISP card slot number, use Print
Program LD 22 to print out the system configuration.
<cr>=print all MISPs in the system
May 1999
-channel packet data.
D