Connection / Power Supply; Radio Connection - Siemens Albatros RVS46 Series User Manual

Mounting without base

Connection / power supply

Radio connection

Establishing the link
Testing
26/138
Siemens
Building Technologies
The room unit is powered by 3 pieces 1.5 V alkaline batteries type AA (LR06).
Make the radio connection in the vicinity of the radio module prior to mounting so that
all systems are within easy reach.
Prerequisite for the radio connection is that all components receive power, which
means that the radio module must be correctly connected to the basic unit and the
batteries must be correctly installed in the room unit.
1. Press the button on the installed radio module for at least 8 seconds until the LED
on the radio module starts flashing at high frequency.
2. Press OK on the room unit to switch to programming.
3. Press the info button for at least 3 seconds and select operating level
"Commissioning"with the setting knob. Then, press OK.
4. Select operating page "Operator unit"and press OK.
5. Select operating line "Used as" (operating line 40) and make the appropriate
selection. Then, press OK.
6. Select operating page "Radio" and press OK.
7. Select setting line "Binding" (line 120). Then, press OK.
8. Set the setting knob to "YES" and press OK. Connection establishment is started.
9. The display shows the progress of connection establishment in %. This process can
take 2 to 120 seconds.
10. The connection is established when "Device ready" appears and the LED on the
radio module extinguishes
The test is made to check the quality of the radio link.
·
The test can be aborted by pressing the ESC button.
·
While the radio link can be opened on the controller, the test should be made at
the location where the room unit will be installed
On the room unit, as described above (points 2 through 4), select operating page
"Radio" and activate the test mode on setting line "Test mode" (line 121).
User Manual
Wireless components
CE1U2353en
2014-07-30