Table of Contents
Advertisement
Voyager Operation and Maintenance Manual
6.0 Maintenance
This section provides instructions for proper
cleaning, inspection and lubrication of the equipment.
To avoid injury to yourself or damage
to the equipment, please read and
understand the instructions in this
manual before you attempt to install,
operate or service the laminator!
6.1 Daily Cleaning
The Laminating Rollers must be kept free of
adhesive throughout the laminating process.
Clean the Chrome Roller with a soft rag and
mineral spirits, preferably while the roller is still
warm.
A Chrome Roller that has recently been in use
may still be hot enough to burn you.
© GBC Films Group April 2000
WARNING
Clean the Counter-Pressure Roller with a soft rag
and solvent. If this cleaning leaves adhesive on
the roller, use a plastic scouring pad, like Scotch-
Brite, to remove the adhesive.
To prevent damage to roller surfaces, never use
metal tools or abrasive cleaners to clean either of
the Laminating Rollers.
6.2 Periodical Maintenance
Lightly oil chains and idler sprockets once a month.
Oil all bushings once a month.
To prevent rust, a light film of WD40 should be
applied to all bare metal parts as necessary.
Lubricate all rollers at the grease fittings on the
bearings every six months.
In some cases, guards may have to be removed.
Be sure to replace them when maintenance has
been completed.
Maintenance
Page 1 - 43
Advertisement
Table of Contents
