Connections - Brother MFC-7300C Owner's Manual

Connections

The external TAD must be plugged into the left side of the MFC, into the jack
labeled EXT. Your MFC cannot work properly if you plug the TAD into a wall
jack.
1
Plug the telephone line cord from the wall jack into the left side of the MFC, in
the jack labeled LINE.
2
Plug the telephone line cord from your external TAD into the left side of the
MFC, in the jack labeled EXT. (Make sure this cord is connected to the TAD at
the TAD's telephone line jack, and not its telephone set jack.)
3
Set your external TAD to four rings or less. (The MFC's Ring Delay setting does
not apply).
4
Record the outgoing message on your external TAD (see below).
5
Set the TAD to answer calls.
6
Set the Receive Mode to TAD:ANSWER MACH.
A S S E M B L Y A N D C O N N E C T I O N S
2 - 11