Connections; Recording An Outgoing Message (Ogm) On The External Tad - Brother mfc-t800 Basic User's Manual

Chapter 6

Connections

The external TAD must be plugged into the
jack labeled EXT on the machine. Your
machine cannot work correctly if you plug the
TAD into a wall jack (unless you are using
Distinctive Ring).
a
Place both hands under the plastic tabs
on both sides of the machine to lift the
scanner cover into the open position.
b
Plug the telephone line cord from the
telephone wall jack into the jack labeled
LINE.
c
Remove the protective cap (1) from the
jack labeled EXT., and then plug the
telephone line cord from the external
TAD into the EXT. jack. (Make sure this
cord is connected to the TAD's
telephone line jack, and not its handset
jack.)
d
Carefully guide the telephone line cord
into the cable channel and out the back
of the machine.
34
e
6
f
g
h
i
Recording an outgoing
message (OGM) on the
external TAD
Timing is important in recording this
message. The way you record this message
will affect both manual and automatic fax
reception.
1
a
b
c
Lift the scanner cover to release the
lock. Gently push the scanner cover
support down and close the scanner
cover using both hands.
Set your external TAD to answer within
four rings. (The machine's Ring Delay
setting does not apply.)
Record the outgoing message on your
external TAD.
Set the TAD to answer calls.
Set the Receive Mode to
External TAD. (See Choose the
correct Receive Mode on page 24.)
Record 5 seconds of silence at the
beginning of your message. (This allows
your machine time to listen for the fax
CNG tones of automatic transmissions
before they stop.)
Limit your speaking to 20 seconds.
End your 20-second message by giving
your Fax Receive Code for people
sending manual faxes. For example:
"After the beep, leave a message or
send a fax by pressing l 5 1 and
Inicio (Start)."
6