Loading Paper; Simultaneous Printing/Fax - Brother MFC-7300C Owner's Manual

Loading Paper

You can use plain paper, coated paper, transparencies, glossy paper, envelopes
and organizer (K, L) in the multi-purpose sheet feeder. (See Chapter 3 for more
information about paper types.)
1
Open the control panel
cover by pulling it toward,
you then lift the top cover
toward the back. When
you want to print on
regular paper, keep the
purple paper thickness
adjustment lever up.
When you want to use
thick paper, press the lever
down. Then, close the top
cover and the control
panel cover.
2
Remove any paper in the Feeder, and load the new paper. Fan the stack of paper
before loading.
3
Load the paper stack with the printing (coated) side facing up. Adjust the paper
guide. Make sure the paper is stacked below the arrow. You can load up to
approximately 100 sheets of 20 lb (75g/m
If you see ink smudges on the top center of the printed pages, press the purple
Note
thickness adjustment lever down.

Simultaneous Printing/Fax

Your MFC can print data from your computer while sending or receiving a fax,
or while scanning information into the computer. However, when the MFC is
copying or receiving a fax on paper, it pauses the PC printing operation, and
resumes when copying or fax receiving is complete. Fax sending will continue
during PC printing.
(For regular paper)
Purple Paper
Thickness Adjustment
Lever
U S I N G T H E M F C A S A P R I N T E R
(For thick paper)
2
) plain paper.
15 - 3