Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 720

4. Press SW3 (the mode button) to select the address. The displayed address changes as
follows each SW3 button is pressed. When the manual setting is selected, the indicators
change as follows:
• Press the SW3 when A9-A16 or A57-A88 is displayed, then A1 will be displayed.
• If connecting multiple signal amplifiers, be sure to select a different address for each am-
plifier.
• If the same address is used for different signal amplifiers, normal communication cannot
be done.
5. Press SW4 (the set button) to set the selected address.
6. Turn the power off and on or press SW7 (the reset button) to exit the address setting mode
and return to the normal mode. If an address setting error occurs ("26" is displayed on the
D19-indicator), the address will not be set. Perform address setting again.
2-19. Signal amplifier
Filter mode: OFF
A1 A2 A3 A4
A8 A7 A6
Filter mode: ON
A1 A25 A26 A27
A56
Example: Address No.5 is selected
D19
Example: Address no.5 is set
D19
D19
Normal mode Address setting error
- (07-120) -
A5
A28 A29
A30
D19
2. Function settings