Signal Amplifier - Fujitsu AIRSTAGE J-IIIL Design & Technical Manual

2-19. Signal amplifier

¢ Switch location
SW3 SW4
¢ Automatic address setting
Refer to "Automatic address setting of signal amplifier"
¢ Manual address setting
1. Turn on the power for the signal amplifier.
2. While holding down SW4 (the set button), press and release SW7 (the reset button) to en-
ter the address setting mode.
The address setting mode is activated only if the set button is held down when SW7 re-
leased.
3. Press SW4 (the set button) to display the current address. The address is set to A1 at the
factory.
2-19. Signal amplifier
D19
SW7
D19
Example 1: When A1 is set
D9
SW1
D14
SW2
on page 07-50.
D19 D19
D19
Example 2: When A12 is set
- (07-119) -
2. Function settings