Wired Remote Controller (Touch Panel) - Fujitsu AIRSTAGE J-IIIL Design & Technical Manual

2-15. Wired remote controller (Touch panel)

¢ Remote controller address confirmation
When "R.C. Address Setting" on the Maintenance screen is touched, Installer Password Verification
screen is displayed.
Enter the Installer Password, and touch "OK". R.C. Address Setting screen is displayed.
Maintenance
Test Run
I.U. Address
Setting
Back
When the "Back" is touched, the display returns to the Maintenance screen.
NOTE: The address of this unit is set automatically. Do not change the indoor unit remote con-
troller address from the factory setting "0". (Verify that the address is "0".)
¢ Manual address setting of the remote controller
1. Touch "Manual Addressing" on the R.C. Address Setting screen.
2. Manual Addressing screen is displayed. Set the address by touching "
When "OK" is touched, a verification screen is displayed.
3. When the "Yes" on the verification screen is touched, a message screen is displayed.
2-15. Wired remote controller (Touch panel)
Page 2/ 3
R.C. Address
Setting
Function Setting
Previous Next
Page Page
R.C.Address Setting
Current Address
Manual Addressing
Address Reset
Manual Addressing
System
001
Cancel
Manual Addressing
Manual address setting will be started. OK?
No
- (07-109) -
R.C.Address Setting
Current Address [001–01]
Manual Addressing
Address Reset
Back
[001–01]
Back
Unit
01
OK
Yes
R.C.address
(Unit No.)
When the address
is set manually, this
mark is displayed.
" or " ".
2. Function settings