Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 672

• SET3-3, SET3-4: Setting prohibited
SET3-3
Off (Fixed)
On (Setting prohibited)
• SET4-1: Switching of Drainage function (for Mini duct type and Slim duct type only)
If the drain pump is not used, this switch should be set at "On (Disabled)".
SET4-1
Off
On
NOTE: When set to "On" (Drainage function: Disabled), be careful not to cause water leakage by
the drainage.
• SET4-2: Switching of Auto louver grille setting (for Mini duct type and Slim Duct type only)
When Auto louver grille kit (optional parts) is attached, this switch should be set "On (Enabled)".
SET4-2
Off
On
• SET4-3: Setting prohibited
• SET4-4: Setting prohibited
• SW1: Switching of Remote controller wire type setting
SW1
2WIRE
3WIRE
2-2. Setting on indoor unit PCB
Off (Fixed)
On (Setting prohibited)
Drainage function
Enabled
Disabled
Auto louver grille setting
Disabled
Enabled
SET4-3
Off (Fixed)
On (Setting prohibited)
SET4-4
Off (Fixed)
On (Setting prohibited)
Remote controller wire type
- (07-72) -
SET3-4
2-wire
3-wire
Factory setting
♦
Factory setting
♦
Factory setting
♦
Factory setting
♦
Factory setting
♦
Factory setting
♦
2. Function settings