Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 611

1
* : Set the remote controller address "0" only.
Address is automatically assigned from Remote controller.
• RB unit branch merging (UTP-RX08AH, UTP-RX12AH)
– PC board layout
• Touch panel controller setting (Set G)
Before performing the initial setting, set the Touch panel controller address first. For details,
refer to the setting manual.
*: The sum total of the Touch panel controller, Central remote controller, Network convertor for
Group remote controller, Modbus convertor, and Network convertor for LonWorks is a maxi-
mum of 16.
1-3. Manual address setting method
00
00 00 0 00 01 0 00 02
R.C.line: 2 wire *1
2 wire type R.C.
- (07-11) -
0 00 03 0 00 04 0
2 wire type R.C.
DIP switch SET2
00 01
Touch panel controller (Max. 16) *
00 05 0
02 03
2
1. System settings