Page 1
7E10 SATA Product Manual 5xxE/4096* 5xxE/4096* Standard models FIPS models Standard models ST10000NM017B ST10000NM021B ST10000NM002B ST8000NM017B ST8000NM021B ST8000NM002B ST6000NM019B ST6000NM023B ST6000NM004B ST4000NM024B ST4000NM028B ST4000NM004B ST2000NM017B ST2000NM004B 5xxE/4096* 5xxE/4096* SED models Non-Mirrored models SED models ST10000NM019B ST10000NM025B ST10000NM006B ST8000NM019B ST8000NM025B ST8000NM006B ST6000NM021B ST6000NM027B ST6000NM008B...
Page 2
Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Exos 7E10, PowerChoice and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. The FIPS logo is a cer- tification mark of NIST, which does not imply product endorsement by NIST, the U.S., or Canadian governments.
For information regarding online support and services, visit: www.seagate.com/contacts/ For information regarding Warranty Support, visit: www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: www.seagate.com/services-software/recover/resources/ For Seagate OEM and Distribution partner and Seagate reseller portal, visit: www.seagate.com/partners Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
• Tarnish-resistant components to help protect drive from environmental elements, increasing field reliability. • Worldwide Name (WWN) capability uniquely identifies the drive. Seagate recommends validating the configuration with the selected HBA/ Note RAID controller manufacturer to ensure use of full capacity is supported. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Shadow Register Block. All Serial ATA devices behave like Device 0 devices. For additional information about how Serial ATA emulates parallel ATA, refer to the “Serial ATA: High Speed Serialized AT Attachment” specification. The specification can be downloaded from www.serialata.org. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the phrases the drive and this drive are used throughout this manual to indicate the Exos 7E10 Serial ATA drive models. Specification summary tables The specifications listed in the following tables are for quick reference.
Page 9
One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. * See Section 2.10, "Reliability" for rated MTBF device operating condition requirements. ** See Section 2.4, "Start/stop times" for additional information. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
COMMAND CHECK field value is taken from the DESCRIPTOR CHECK field in the descriptor specified by the SECTOR CONFIGURATION DESCRIPTOR INDEX field SECTOR CONFIGURATION DESCRIPTOR INDEX field specifies the Sector Configuration descriptor in the Set Sector Configuration log page Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 11
Bit Description 7 DESCRIPTOR VALID bit 6:0 Reserved Byte LOGICAL TO PHYSICAL SECTOR RELATIONSHIP SETTING field 2...3 Word DESCRIPTOR CHECK field 4...7 DWord LOGICAL SECTOR SIZE SETTING field 8...15 Bytes Reserved Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
5 to 20 seconds. Extended time to ready is dependent on cache state and environmental conditions prior to the unexpected power loss and during the subsequent power on. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
0.559 10.99 Maximum DC (Peak) 1.032 0.724 During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 14
0.476 9.77 Maximum DC (Peak) 0.94 0.653 During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 15
0.40 8.71 Maximum DC (Peak) 0.904 0.523 During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 16
0.322 7.78 Maximum DC (Peak) 0.895 0.436 During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
• Using 5V power, the drive is expected to operate with a maximum of 100mV peak-to-peak sine-wave injected noise at up to 10MHz. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. Note 2.5.4 Voltage tolerance Voltage tolerance (including noise): 5V ±5%12V ± 10% Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
• Saved enabled state, and timer value • Current enabled state, and timer value S.M.A.R.T. Read Data Reports • Attribute 192 - Emergency Retract Count • Attribute 193 - Load/Unload Cycle Count Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 19
Disable EPC Feature Set PowerChoice Supported Extended Power Condition Identifiers Power Condition Identifiers Power Condition Name Standby_z 01 - 80 Reserved Idle_a Idle_b Idle_c 84 - FE Reserved All EPC Power Conditions Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Non-operating –40° to 158°F (–40° to 70°C) package ambient with a maximum gradient of 36°F (20°C) per hour. This specification assumes that the drive is packaged in the shipping container designed by Seagate for use with drive. 2.6.2 Humidity The values below assume that no condensation on the drive occurs.
Linear Random Non-Operating Vibration The drive will not incur physical damage or have non-recoverable errors after being subjected to the power spectral density noise specified below. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Test for Prominent Discrete Tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
The useful life of any electronic equipment may be extended by replacing materials near circuitry with sulfide-free alternatives. Seagate recommends that data centers be kept clean by monitoring and controlling the dust and gaseous contamination. Gaseous contamination should be within ANSI/ISA S71.04-2013 G2 classification levels (as measured on copper and silver coupons), and dust contamination to ISO 14644-1 Class 8 standards, and MTBF rated conditions as defined in the Annualized Failure Rate (AFR) and Mean Time Between Failure (MTBF) section.
Seagate’s option and at no charge to the customer, if returned by customer at customer’s expense to Seagate’s designated facility in accordance with Seagate’s warranty procedure.
For installations which require cables, users can connect the drive as illustrated in Figure Figure 2. Attaching SATA cabling Each cable is keyed to ensure correct orientation. Exos 7E10 Serial ATA drives support latching SATA connectors. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
2 .138±.015 2.000 60 C MAX 1.028 MAX [26.10MM] Figure 3. Mounting configuration dimensions 5-disk models Note The image is for mechanical dimension reference only and may not represent the actual drive. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 27
Figure 4. Mounting configuration dimensions 4-disk models Figure 5. Mounting configuration dimensions 3-disk models Note The image is for mechanical dimension reference only and may not represent the actual drive. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate’s SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two ATA commands: •...
In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: The download must be an SED file.
The drive shall not support the OVERWRITE EXT and BLOCK ERASE EXT sub-commands. Support of the SANITIZE FREEZE LOCK EXT command shall be determined on a customer-specific basis. OEM drives shall support the command. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Figure 6. Example of FIPS tamper evidence labels. Image is for reference only, may not represent actual drive Note Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
For detailed information about the Serial ATA interface, refer to the “Serial ATA: High Speed Serialized AT Attachment” specification. Hot-Plug compatibility Exos 7E10 Serial ATA drives incorporate connectors which enable users to hot plug these drives in accordance with the Serial ATA Revision 3.2 specification. This specification can be downloaded from www.serialata.org.
Multiword DMA active and modes supported (see note following this table) x0007 Advanced PIO modes supported (modes 3 and 4 supported) 0003 Minimum multiword DMA transfer cycle time per word (120 ns) 0078 Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 37
Bits 7:2 indicate individual SCT feature support. 207-208 ATA-reserved 0000 Alignment of logical blocks and physical blocks 4000 210-221 Vendor specific xxxx Transport major version number x11FF 223-254 ATA-reserved 0000 Integrity word xxA5 Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 38
Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Enable read look-ahead (read cache) feature (default). Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above. Note Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Exos 7E10 Serial ATA Product Manual, Rev. B...
Page 41
Seagate Technology LLC AMERICAS Seagate Technology LLC 47488 Kato Road, Fremont, California 94538, United States, 510-661-1000 Publication Number: 200440800, Rev. B August 2021...