Troubleshooting - Canon Oce VarioPrint 6000+ Series Operation Manual

Troubleshooting

Introduction
When a paper jam occurs in the puncher, the printer will stop printing and go on hold. The printer
operator panel displays a message that asks you to remove the sheets from the puncher. The
printer operator panel does not display the required actions step by step. Therefore, you must
check the following places for jammed media.
• The bypass
• The downward paper path
• The die set
• The bottom of the paper path
• The upward paper path.
Besides a paper jam, there are other possible problems the puncher can face. This section
describes the actions you must take to solve the problems.
Solve a problem
Solve a problem
Problem
The puncher does not punch
You cannot easily pull out the
die set
Solution
• Check if the power switch
tion.
• Check if the power cord is correctly attached to the back of
the puncher.
• Check if the power cord is correctly plugged into the wall
socket.
The die set is in a partial cycle. Turn knob K3/K7 clockwise un-
til the puncher is in the home position. Then the black lines
on the knob (3) and the frame are aligned. The die set should
now slide out easily.
Chapter 10 - Optional finishers and other devices
Troubleshooting
of the puncher is in the 'I' posi-
179