Canon Oce VarioPrint 6000+ Series Operation Manual page 207

Overview of Possible Job Errors
Handle job errors
Error
The required sup-
plies are not
available
The defined com-
bination of job
settings is not
possible
Overview of the possible toner pollution problems using media with high amounts of paper
dust
When you use media with a high amount of paper dust, you can have problems with toner
pollution of the prints right after the automatic black image cleaning procedure. Therefore it is
advised to enable the [Paper quality test] (see
Paper quality test on page
that the correct [Paper quality] setting is still at the right level for this new batch.
Toner pollution problem
Toner pollution on the first sheets af-
ter the automatic black image clean-
ing procedure.
Solution
Add the required supplies
(media, toner and staples)
before the machine stops
printing.
• The controller corrects
the settings.
• You must define a cor-
rect combination of job
settings in the [Proper-
ties] section of the
[Jobs] view on the con-
trol panel.
84) each time when a new batch of media is used. This is to be sure
Solution
• Change the [Paper quality] setting from [Normal] to
• Use the [Paper quality test] to determine if this new
• The sheets of the 5
• When these sheets still show toner pollution, you can
• Use the [Paper quality test] to verify that this new set-
Additional information
The dashboard helps you to determine when
the supplies are required.
The solution depends on the place where the
job settings are defined.
• When the job settings are defined in an ap-
plication or printer driver, the controller au-
tomatically corrects the settings.
• When you define the job settings on the
control panel, the control panel displays a
message that the defined combination is not
possible. The [OK] button is disabled.
Change the advanced media settings - Start the
Change the advanced media settings -
[Low] (see
Change the Paper quality on page
setting is the right cleaning mode for this media.
th
set must be totally toner free, al-
so at the edges of the media size width.
set the [Paper quality] setting to [Lower] (see
the advanced media settings - Change the Paper qual-
ity on page
83).
ting is the right cleaning mode for this media.
Chapter 12 - Keeping the printer running
Troubleshooting
83).
Change
4
207