Table of Contents
Advertisement
11 May, 2001
Mode No.
RAM Clear
-1
Total Counter Unit
Setting
-2
Inch/mm Exchange
-3
-4
Not Used
Registration
Adjustment
-5
Light Sensor
Adjustment
-6
Function
Clears selected data items from the
RAM.
To clear the memory, input the number
of the item you want to delete, then
press the " key.
Note:
If all the memory is cleared (if a
number from 20 to 28 is selected), you
must reenter the roll cutter settings
from the decal attached inside the
upper right cover.
Please refer to page 4-25 for the
default settings for each destination.
(When No. 10 to 26 is selected.)
Selects the unit which the total counter
counts by.
Selects the unit in which the edge
margin and paper length is indicated
by.
Adjusts the paper registration for the
by-pass feed. When this setting is
changed, the same setting will be set
for SP#-45 (Roll Feeder Registration).
Change the settings for the light
sensor.
While in this mode, the exposure lamp
can be turned ON and OFF using the
Copy Media key.
Tracing paper: ON
Film: OFF
4-13
SERVICE TOOLS
Data
21: Clear all the memory
and change the
settings to the U.S.A.
version
22: Clear all the memory
and change the
settings to the Europe
version
23: Clear all the memory
and change the
settings to the Asia
version
24: Clear all the memory
and change the
settings to the NRG
version
25: Clear all the memory
and change the
settings to other
Other 1 version
26: Clear all the memory
and change the
settings to other
Other 2 version
27: Clear all the memory
and change the
settings to other
Other 3 version
28: Not Used
29: Not Used
30: Clear all the memory
0: 1 yard
1: 1 m
2: 100 inches
3: 50 inches
4: A1 length (594 mm)
5: Sheet (Any size)
6: 1 foot
0: mm
1: Inch
0: Standard
–9.9 ← 0 → 9.9 mm
Advance
Delay
50: Standard
0 ← 50 → 99
Darker
Lighter
Advertisement
Table of Contents
