Table of Contents
Advertisement
INSTALLATION PROCEDURE
B435I106.WMF
B435I108.WMF
8. Remove the roll feeder's rear cover [A] (6 screws).
9. Remove the copier's rear cover [B] (2 screws).
10. Remove the small caps [C] from the copier's rear cover using cutting pliers.
11. Install the roll feeder drive board [D].
12. Connect the following harness connectors as shown.
DC harness [E] — Roll Feeder Drive board
Joint harness [F] — Roll Feeder Drive board
Joint harness [G] — Copier Main Control board (3 clamps)
AC harness [H] — AC Drive board [I]
[B]
[A]
[G]
B435I124.WMF
[E]
[D]
3-24
[B]
[C]
[F]
[I]
11 May, 2001
B435I122.WMF
[D]
[H]
B435I110.WMF
Advertisement
Table of Contents
