Ricoh J2SS-C3 Service Manual page 73

11 May, 2001
Mode No.
No Misfeed
Detection Mode
-52
Free Run Mode
-53
-54 Not Used
Toner End
Recovery
-55
Used Toner Full
Condition Detection
-56
Roll Feed Speed
Correction
-57
(Plain Paper)
Roll Feed Speed
Correction
(Translucent Paper)
-58
Roll Feed Speed
Correction
-59
(Film)
Fluorescent Lamp
Abnormal Time
Check 1
-60
Function
Ignores jam error signals, except for
initial jams. The setting automatically
resets to "0" when the main switch is
turned off.
The machine caries out copy operation
without an original. This mode can be
used if the optional roll feeder is
installed and selected paper length is
more than 594 mm.
The machine starts operation when the
roll feed select key is pressed, and
stops when the Emergency Stop key is
pressed.
Sets the process for toner end
recovery. When set to the default
value, the toner density is checked as
described in the Toner Density Control
section 2.4.2.
Forced recovery skips this testing
procedure, and just clears the toner
end condition.
When the toner overflow counter is
used, this sets the maximum copy
length. Once the counter reaches this
value, the used toner full condition is
triggered.
Not used. Do not change this setting
The fusing section's transport speed is
slightly faster than the roll feeder's.
This is done to stretch the copy paper.
However, due to over-stretching,
creases may develop along the trailing
edge when the copy paper is longer
than 1,200 mm. To prevent this, the
roll feeder's speed is increased slightly
every second once the paper feed
length exceeds 1,200 mm. The speed
is changed 5 times.
5 in this SP can be used to set the final
roll feed speed equal to the fusing
section's. Do not change this value in
the field. It is for designer use only.
Not used. Do not change this setting.
Tracks the amount of time that the
exposure sensor is more than 1 V
higher than the target value.
4-19
SERVICE TOOLS
Data
0: Normal
1: No Misfeed Detection
0: Normal
1: Next Paper is fed
when the fusing exit
sensor is deactivated.
2 ~ 250:
Next paper is fed (X-
1) seconds after the
fusing exit sensor is
deactivated.
X = Input Number
0: Normal
1: Forced recovery
0: Toner overflow
sensor
1: 840 m
2: 480 m
3: 1,180 m
0 ← 5 → 10
Slower Faster
0 ← 5 → 10
Slower Faster
0 ← 5 → 10
Slower Faster
0 ~ 250:
The total time
(seconds) that the lamp
voltage is more than 1
volt higher than the
target value.