Table of Contents
Advertisement
11 May, 2001
Mode No.
Toner Overflow
Detection Setting
51
Used Toner
Counter
52
Used Toner
Counter Clear
53
Developer
Warm-up Setting
54
Paper Length Limit
Setting
55
Copy Number Limit
Setting
56
Function
Determines the maximum copy length
that can be made after the toner near
overflow condition has been detected.
Indicates the maximum copy length
that can be made before the used
toner near overflow condition is
triggered
This counter is automatically cleared
when the toner overflow condition is
cleared after emptying the used toner
in the bottle.
Manually clear the used toner counter.
Sets the developer agitation time.
If the fusing temperature is lower than
60°C when the main switch is turned
on, the main motor rotates for the set
amount of time, generating a
triboelectric charge on the developer
and toner.
Determines the maximum paper
length.
Note:
If paper longer than 2,000 mm is used,
you may experience skewed or
creased copies, poor fusing, or
damage to the original.
Determines the maximum number of
copies. The default settings for the
B047 and B048 copiers are different.
4-7
SERVICE TOOLS
Data
0: 30 m
1:
6 m
2: 53 m
3: 77 m
4: 100 m
5: 142 m
tF=XX,XXX (Beeper)
0: Full toner condition
is not detected
1: Full toner condition
is detected.
To clear the counter, input
"0" even if "0" is already
indicated.
0: 50 seconds
1: 2 minute
2: 3 minute
3: None
(In mm mode)
0: 3,000 mm
1: 3,600 mm
2: 5,200 mm
3: 6,800 mm
4: 8,400 mm
5: 9,999 mm
(In inch mode)
0: 118.0 inch
1: 160.0 inch
2: 240.0 inch
3: 320.0 inch
4: 400.0 inch
5: 480.0 inch
0: 99 sheets (B047)
1: 10 sheets (B048)
2: 20 sheets
3: 30 sheets
4: 40 sheets
5: 50 sheets
6: 60 sheets
7: 70 sheets
8: 80 sheets
9: 90 sheets
Advertisement
Table of Contents
