Ricoh J2SS-C3 Service Manual page 42

INSTALLATION PROCEDURE
[A]
B440I117.WMF
[G]
B440I121.WMF
1. Place the copy tray stay [A] under the copy tray as shown.
2. Adhere the copy tray sheets (the Mylar strips with rubber pads) [B] to the
table's middle plate [C]. Make sure the center copy tray sheets is positioned
between the screw holes [D] on the copy tray as shown. The left and right copy
tray sheets should be positioned over the screw holes.
3. Lift the copy tray stay and install the two stepped screws [E] to the left and right
side plates [F, G]. After the screws are in place, hook the copy tray stay [A] on
the screws. Then secure it to the left and right side plates (2 screws for each:
M4x6 with flat washers).
NOTE: Be careful when installing the copy tray stay. Do not scratch the
surface of the table.
4. Install the copy tray support [H] (2 screws: M4x6 with flat washers).
[E]
[A]
[D]
[F]
3-16
11 May, 2001
[C]
[B]
B440I118.WMF
[H]
B440I119.WMF