Omron Sysmac CJ Series Connection Manual page 61

9 .4.2. List of Fixed
The tables below list the addresses necessary to execute
●Alloca ed CIO t are as
The following allocations cannot be changed be
unit number that is set for the SCU Unit.
In this program, the unit number is set to 0.
Address Data type
1518.15 BOOL
1519.1 0 BOOL
1519.11 BOOL
1519.15 BOOL
1519 UINT
Additional Information
For de tails o n th e area allocated to
C J-se ries S eria l Communications Bo
Manual (Cat.No. W336).
●Related Auxiliary Area
The add ress o f the following related aux
(internal logical port) specified in the program (op
be c hang ed fre ely.
This program uses Communications Port (internal
Address
A202.07 BOOL
Additional Information
For information on related auxiliary area for the PMCR instruction, refer to Related Auxiliary
Area Words and Bits of Chapter 3 Instructions - Serial Communications instructions (PMCR)
of CJ series Instructions Reference Manual (Cat.No. W474).
Allocations
TransmissionError_SCU_F_P1
SequenceAbor
SequenceEndCompletion_SCU_F_P1
ProtocolMacroExec
ProtocolMacroErrorCode_SCU_F_P1
the SCU
ards an
iliary ar
Data type
CommPortEnabledFlag_P7
this program.
cause they are determined according to th
Symbol name
tCom pletion_SCU_F_P1
uting_SCU_F_P 1
Unit, refer to Section 2-3-2 CIO Area
d Serial Communications Units Operation
ea corresponds to the communications port
erand of PMCR instru
logical port) No.7.
Symbol name
9. Program
e
of the
ction). Thus, it must not
58