Omron sysmac NJ Series Connection Manual page 23

3
Start Sysmac Studio.
*If the User Account Control
Dialog Box is displayed at start,
make a selection to start
Sysmac Studio.
4
Sysmac Studio starts.
Click New Project.
5
The Project Properties Dialog
Box is displayed.
6
Select Measurement Sensor
from the pull-down list of
Category in the Select Device
Area.
7
Check that the category and the
device in the Select Device Area
are set as shown below.
Category: Measurement
Sensor
Device: ZW
Click Create.
7．EtherNet/IP Connection Procedure
20