Create Span Array - Biostar M6TSU User Manual

Chapter 3

3.3.7 Create Span Array

Please follow the steps below to create the span array:
1. Click Span
2. In the popup window, select hard disks from
Add them into
corresponding arrow. Then click
3. In the follow-on confirmation dialog box , please click
to start the creation or click
the user selects Cancel, the system will remain unchanged.
4. After the create operation is complete, please shut down all other
programs. And then click
also select No
Note:
At least two hard disks are needed in the creation of the span array. Disks
can be connected at any cable and set as either master or
slave device.
Warning:
In the creation of the span array, only the data on the first member disk
will be preserved while the data on others will be completely destroyed.
icon on the tool bar.
Span Array Member Disks
Next to continue.
Cancel button to cancel the creation . If
Yes to restart the computer. The user may
to restart the computer later.
3-24
Trouble Shooting
Available Disks column.
column by clicking the
Create button