Biostar M6TSU User Manual page 52

Chapter 2
The Choices: Half (default), Full.
Use IR Pins
Consult your IR peripheral documentation to select the correct setting of the TxD
and RxD signals.
The Choices: IR-Rx2Tx2 (default), RxD2 TxD2.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with
which I/O Address.
The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The default value is SPP.
SPP (default)
EPP
ECP
ECP+EPP
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9.
The Choices: EPP1.7 (default), EPP1.9.
ECP Mode Use DMA
Select a DMA Channel for the port.
The Choices: 3 (default), 1.
Using Parallel Port as Standard
Printer Port.
Using Parallel Port as Enhanced
Parallel Port.
Using Parallel Port
Capabilities Port.
Using Parallel Port as ECP & EPP mode.
Supports EPP or ECP mode.
2-17
BIOS Setup
as Extended