Biostar M6TSU User Manual page 60

Chapter 2
IRQ-3
IRQ-4
IRQ-5
IRQ-7
IRQ-9
IRQ-10
IRQ-11
IRQ-12
IRQ-14
IRQ-15
The above settings will be shown on the screen only if "Manual" is chosen for the
resources controlled by function.
Legacy is the term, which signifies that a resource is assigned to the ISA Bus and
provides non-PnP ISA add-on cards. PCI / ISA PnP signifies that a resource is
assigned to the PCI Bus or provides for ISA PnP add-on cards and peripherals.
The Choices: Disabled (default), Enabled.
Resources Controlled By
By Choosing "Auto(ESCD)" (default), the system BIOS will detect the system
resources and automatically assign the relative IRQ and DMA channel for each
peripheral.By Choosing "Manual", the user will need to assign IRQ & DMA for
add-on cards. Be sure that there are no IRQ/DMA and I/O port conflicts.
IRQ Resources
This submenu will allow you to assign each system interrupt a type, depending on
the type of device using the interrupt. When you press the "Press Enter" tag, you
will be directed to a submenu that will allow you to configure the system
interrupts. This is only configurable when "Resources Controlled By" is set to
"Manual".
assigned to: PCI Device
assigned to: PCI Device
assigned to: PCI Device
assigned to: PCI Device
assigned to: PCI Device
assigned to: PCI Device
assigned to: PCI Device
assigned to: PCI Device
assigned to: PCI Device
assigned to: PCI Device
2-25
BIOS Setup