Stamina Muuv Bike Owner's Manual page 21

OPERATIONAL INSTRUCTIONS
To wear the HEART RATE TRANSMITTER(106) around the chest, make the red LED indicator on the HEART
RATE TRANSMITTER(106) upward. Attach the clasp end of the ELASTIC SENSOR STRAP(107) to the
loop end of the ELASTIC SENSOR STRAP(107), and adjust the ELASTIC SENSOR STRAP(107) to
fit your chest snugly as shown in the illustration below. Apply water or conductive gel to moisten the
rate sensor electrodes. These
to properly detect your heart rate.
(107)Elastic Sensor Strap
Clasp
T h e r e d L E D i n d i c a t o r o n t h e H E A R T R AT E
TRANSMITTER(106) will flashing when detected active
pulse. Automatically shut off after five minutes of inactivity.
OPERATION DESCRIPTIONS
1. If your heart rate is inconsistent or not tracking on your workout monitor, do the following:
The HEART RATE TRANSMITTER(106) will connect to your device while using the unit and within 10
feet of close proximity to your device. If you are too far from your device the connection will be lost.
Moisten the heart rate
make sure they are in contact with the skin. Your skin may be dry when you begin your workout and
the moisture is necessary to ensure contact. As you sweat, contact will improve.
Tighten the elastic strap so it remains in place as you exercise. Movement of the
electrodes will result in inaccurate or erratic signal and readings.
Body hair affects the detection and transmission of heart rate signals. If necessary, trim or shave chest
hair so that the
Clean the heart rate
water and dry with a soft towel.
2. Always make sure to pair the HEART RATE TRANSMITTER(106) with your device in the müüv app
via Bluetooth. If the HEART RATE TRANSMITTER(106) has been paired with your device, not in the
müüv app, please remove the pairing from your device, then redo the pairing in the müüv app.
3. Avoid using the HEART RATE TRANSMITTER(106) at temperatures below -10ºC (14ºF), as this will
slow down the display of heart rate readings.
4. The HEART RATE TRANSMITTER(106) is not a medical device, nor intended for medical diagnostic
purposes. Maintaining a consistent signal can be difficult due to the moving during riding the bike. The
pulse function is a great tool to optimize your workout, but should be used as a reference only.
Transmitter Care and Maintenance
Wash regularly with mild soap and water solution and dry with a soft towel being careful not to scratch
the heart rate sensor electrodes.
Store in a cool, dry place. Make sure the
and never store a wet transmitter in non-breathable material like a plastic bag or sports bag.
Do not stretch the
NOTE: The frequency of the Bluetooth HEART RATE TRANSMITTER(106) is 2.4 GHz. All compatible
heart rate transmitters from other companies will work with the SMART MOUNT(45).
heart rate sensor electrodes must be wet and in contact with your chest skin
(107)Elastic Sensor Strap
Loop End
sensor electrodes on the back of the ELASTIC SENSOR STRAP(107) and
heart rate sensor electrodes touch the skin.
sensor electrodes as dirt can interfere with transmission. Use a mild soap and
heart rate sensor electrodes.
heart rate sensor electrodes aren't stored with any wet material
21
LED Indicator
Upward
heart rate
heart
sensor