Stamina Muuv Bike Owner's Manual page 15

ASSEMBLY INSTRUCTIONS
STEP 5:
There is a strap attached inside of the HANDLEBAR POST(13) to assist in pulling the CONTROL
CABLE(103) and CONNECTING WIRE(104) through the HANDLEBAR POST(13). Tie the strap to the plug
ends of the CONTROL CABLE(103) and CONNECTING WIRE(104). Pull the strap from the top end to pull
the cables to through and extend out from the hole at the front of the HANDLEBAR POST(13) as shown in
the below illustration. Loosen and pull the UPRIGHT LOCKING LEVER(49), then insert the HANDLEBAR
POST(13) into the MAIN FRAME(1). Insert the pin of the UPRIGHT LOCKING LEVER(49) into one of the
adjustment holes in the HANDLEBAR POST(13). Tighten the UPRIGHT LOCKING LEVER(49) to lock the
HANDLEBAR POST(13) in position.
NOTE: Don't remove the strap from the CONTROL CABLE(103) and CONNECTING WIRE(104) until
instructed to do so in later assembly steps.
STEP 6
NOTE: The RIGHT PEDAL(23) has right hand threads and is tightened by turning clockwise. The LEFT
PEDAL(17) has left hand threads and is tightened by turning counterclockwise.
Thread the RIGHT PEDAL(23) into the RIGHT CRANK(22) as shown. The shoulder of the RIGHT PEDAL(23)
must be in contact with the RIGHT CRANK(22). Tighten the pedal securely or it will come loose and fall
off during use and strip the threads. Do the same to attach the LEFT PEDAL(17) to the LEFT CRANK(18).
CAUTION: Check that the PEDALS(23,17) are fully tightened prior to each use. If the pedals are not tight
against the cranks they will come loose and fall off during use.
Shoulder
Use the Combination Wrench to
securely tighten the LEFT PEDAL
(17) by turning counterclockwise.
Shoulder
15
Strap
Use the Combination Wrench
to securely tighten the RIGHT
PEDAL(23) by turning clockwise.