Stamina Muuv Bike Owner's Manual page 20

OPERATIONAL INSTRUCTIONS
HEART RATE TRANSMITTER
The Bluetooth HEART RATE TRANSMITTER(106) is compatible with iPhone 4s or above, iPod Touch
(5th or above generation), iPad (3rd or above generation). It is also compatible with Android 4.3 or above
with Bluetooth smart support of smart phones and tablets.
To connect the HEART RATE TRANSMITTER(106) to your device:
1. Wear the HEART RATE TRANSMITTER(106) around your chest.
2. Open the müüv app on your device.
3. Go to the Bluetooth settings section of the müüv app and find the heart rate transmtter. When your
heart rate transmtter is found, the ID should look like " HR08_xxxxxx ", tap connect.
NOTE: If the HEART RATE TRANSMITTER(106) does not attach to the ELASTIC SENSOR STRAP
(107). You still can connect it to your device, open the müüv app on your device. Go to the
Bluetooth settings section of the müüv app, and place the HEART RATE TRANSMITTER(106)
close to your device, within 100 cm (39.4 in.). Touch the two metal buttons on the back of the
HEART RATE TRANSMITTER(106) with fingers to send a signal and hlep your device to find
the HEART RATE TRANSMITTER(106). When your heart rate transmtter is found, tap connect.
Using the Heart Rate Transmitter Chest Strap
The HEART RATE TRANSMITTER(106) worn around the chest is powered by a BUTTON BATTERY
(CR2032)(110) located in the back of the HEART RATE TRANSMITTER(106). Two electrodes on
the ELASTIC SENSOR STRAP(107) monitor your heartbeat, and the adjustable ELASTIC SENSOR
STRAP(107) holds the transmitter in place. The HEART RATE TRANSMITTER(106) picks up your heart
rate information and displays it on the monitor of your device during the workout.
To assemble the HEART RATE TRANSMITTER(106),
insert the BUTTON BATTERY(CR2032)(110) as shown
in the illustration. Place the BATTERY RUBBER
RING(108) on the edge of the opening and place
the BATTERY COVER(109) over the BUTTON
BATTERY(CR2032)(110). Using a coin or similar object,
press down on the BATTERY COVER(109) and turn
to securely close the cover.
NOTE:
1. Make sure to close the BATTERY COVER (109) very
tightly as illustrated to prevent sweat and moisture
from damaging the battery.
2. The HEART RATE TRANSMITTER(106) is latex free
and its material is appropriate for human contact.
Refer to the illustration. Press the HEART RATE TRANSMITTER(106)
onto the buttons on the ELASTIC SENSOR STRAP(107).
NOTE: Before wearing the HEART RATE TRANSMITTER(106),
you can check the transmission status by pressing the
heart sensor electrode areas with your fingers. If the red
LED indicator on the HEART RATE TRANSMITTER(106)
flashes, it indicates that it is in normal working condition.
open
(107) Elastic
Sensor Strap
20
close
(109) Battery Cover
(108) Battery Rubber Ring
(110) Button Battery
(106) Heart Rate Transmitter
Heart Rate
Sensor Electrodes
(107) Elastic
Sensor Strap
(106) Heart Rate Transmitter