Stamina Muuv Bike Owner's Manual page 14

ASSEMBLY INSTRUCTIONS
STEP 2
Make the MOVING WHEELS(60) on the FRONT STABILIZER(2) face the front, then attach the FRONT
STABILIZER(2) to the MAIN FRAME(1) with BUTTON HEAD BOLTS(M8x1.25x65mm)(63) and
WASHERS(M8)(64).
STEP 3
Attach the REAR STABILIZER(3) to the MAIN FRAME(1) with BUTTON HEAD BOLTS(M8x1.25x65mm)
(63) and WASHERS(M8)(64).
NOTE: See page 17 for detailed leveling instructions to prevent rocking.
STEP 4
Loosen and pull the ADJUSTMENT KNOB(48), then adjust the SEAT POST(6) to a higher position. Refer
to the detail view below. Attach the SEAT(9) to the SEAT SLIDER(8) by inserting the connector of the SEAT
SLIDER(8) into the SEAT(9). Adjust the SEAT(9) by raising or lowering the front of the SEAT(9) until the top
of the SEAT(9) is parallel to the floor, and make the SEAT(9) point straight forward then securely tighten
the NUTS(M8x1.25) under the SEAT(9).
NOTE: The pin of the ADJUSTMENT KNOB(48) must be inserted into one of the adjustment holes in the
SEAT POST(6) and the ADJUSTMENT KNOB(48) must be screwed in tight to ensure that the
SEAT POST(6) will fit securely in the MAIN FRAME(1).
Nut
14