Display Messages; Switching Off The Machine - Saeco IDEA RST Technical Manual

9.8

Display Messages

A list of alarms (in addition to those
explained before) that can be displayed
and the relative machine conditions is given
below.
STANDBY
The machine is switched off (the power button is set to "I") and the
automatic switching-on/off
"Description of Messages in the Programming Menu").
LOAD THE CIRCUIT
This message is displayed when the machine detects no water in the
boilers during a beverage dispensing cycle.
After checking if there is actually water in the water network, press
the "Up" button, until water comes out regularly from the dispensing
spout and from the coffee dispensing spout. In the COFFEE version,
water only comes out from the coffee dispensing spout.
EMPTY GROUNDS
It is displayed when the coffee grounds drawer is almost full (the
machine has performed the programmed number of brewing cycles).
Anyway, more brewing cycles can be performed.
OUT OF SERVICE – EMPTY GROUNDS
The coffee grounds drawer is completely full (the machine has
performed the programmed number of dispensing cycles).
The machine is blocked and no more dispensing cycles can be
performed until the drawer is emptied.
CLOSE SERV. DOOR
The door is not properly closed.
INS. GROUND DRAWER
The coffee grounds drawer is not properly inserted.
INS. BREW GROUP
The brew group is not properly inserted.
BREW GROUP ERROR
The brew group does not work properly; switch off the machine and
contact the AUTHORISED SERVICE CENTRE.
PUMP ERROR 1-2 or 3-4
One of the pumps is faulty. The machine is still working but it is
necessary to contact the AUTHORISED SERVICE CENTRE.
SENSOR ERROR 1 2
It is displayed when there is a faulty temperature sensor. Switch off
the machine and contact the AUTHORISED SERVICE CENTRE.
TEMPER. ERROR
It is displayed when one of the boiler heating elements is faulty.
Switch the machine off and contact the AUTHORISED SERVICE
CENTRE.
Filter alarm
The machine needs this intervention after performing the
programmed number of dispensing cycles. The softener maintenance
is at the user's expenses, while the cartridge replacement is at the
AUTHORISED SERVICE CENTRE expenses.
Interventions are set according to the machine working cycles and
can be programmed by the maintenance technician.
MAINTENANCE
It is displayed when the machine needs maintenance and after
performing the programmed number of dispensing cycles. Switch off
the machine and contact the AUTHORISED SERVICE CENTRE.
function is enabled (see
Maintenance interventions are set according to the machine working
cycles and can be programmed by the maintenance technician.
9.9

Switching Off the Machine

Programmed automatic switching-off
This is possible when the function "Automatic start-up" is active and
the function "On/Off time" has been programmed.
The machine goes in "Standby" mode at the programmed time.
Manual switching-off
This switching-off is necessary when the function "Automatic
start-up" is not active.
section
It can be obtained by setting both the power button and the all-pole
switch to "0" or by disconnecting the plug.
English
45